Epson EMP-TW1000 Service Manual page 50

When the (operation) indicator is lit or flashing
When the (warning) indicator is off
Standby condition
Orange
Warm-up in progress
Green
Projection in progress
Green
cool-down in progress
Orange
SEIKO EPSON
EMP-TW1000
normal
If you press , projection will start after a brief interval.
Warm-up time is approximately 30 seconds.
Power off operations are ignored while warm-up is in progress.
Normal operation is in progress.
Cool-down time is approximately 30 seconds.
After cool-down is complete, the projector goes to standby mode.
You cannot use the remote control or the projector's control panel
during cool-down.
If the main power switch at the rear of the projector is turned off
before cool-down is complete, wait for the lamp to cool down
(normally about one hour is required) before turning the power back
on again.
2-23
: Lit : Flashing
Revision:A