Exterior Check - Epson EMP-TW1000 Service Manual

3.2.1 Exterior Check

START
Upper Case Unit
Front Case
Control Panel
Projection Lens Unit
IF Case
Lower Case
Air Filter
Lamp Lid Unit
Lamp Assy.
Adjustable Front Foot Unit
Interface Connectors
AC Inlet
Air Filter/Lamp Unit
Installation
SEIKO EPSON
EMP-TW1000
• There should be no damage, deformation or cracking due to external forces.
• The lower case should be installed correctly.
• The remote signal receiver should be clean and free from foreign materials.
• Air vents should be clean.
• The Upper Case should be correctly installed.
• No buttons should be stuck down.
• The Vertical lens adjustment dial and Horizontal lens adjustment dial should turn
smoothly.
• The Lens should be clean and free from damage.
• There should be no damage, deformation or cracking due to external forces.
• The remote signal receiver should be clean and free from foreign materials.
• There should be no damage, deformation or cracking due to external forces.
• The vent hole should be clean and free from any foreign materials.
• The Air filter should be installed to the lower case correctly.
• Remove the Air Filter from the Lower Case to check that it is clean.
• The Lamp lid should be securely attached to the Lower Case.
• The Lamp Lid Detection Switch latch should be free from damage.
• Plastic frame should be free from any deformation, damage or discoloration from
heat. Remove the Lamp Assy. to check.
• Power supply connector should be free from discoloration.
• The glass surface of lamp should be clean.
• Can the projection height be adjusted with the foot unit?
• The connectors and terminals should not be bent or discolored.
• The connectors and terminals should be free from foreign materials.
• The AC Connectors should not be discolored.
• The AC source Socket should be free from damage.
3-4 Revision:A