Storing Accessories - Makita 2702X1 Instruction Manual

334 mm
1
(13-1/8")
1. Hole diameter 8 mm (5/16")
1
25 mm (1")
2
1. 6 mm (1/4") Std. washer
2. No. 10 wood screw 40 mm (1-1/2")
min. length
1
1. 6 mm (1/4") Std. washer
2. 6 mm (1/4") Machine bolt & nut
tighten securely
1
1. Miter gauge
1
1. Rip fence
Positioning table saw
Locate the table saw in a well lit and level area where
459 mm
you can maintain good footing and balance. It should
(18-1/16")
be installed in an area that leaves enough room to easi-
ly handle the size of your workpieces. The table saw
should be secured with four screws or bolts to the work
bench or table saw stand using the holes provided in
the bottom of the table saw. When securing the table
saw on the work bench, make sure that there is an
opening in the top of the work bench the same size as
the opening in the bottom of the table saw so the saw-
dust can drop through.
If during operation there is any tendency for the table
saw to tip over, slide or move, the work bench or table
saw stand should be secured to the floor.
NOTE:
• Models 2702X1 and 2703X1 are standard-equipped
with a table saw stand.
2

Storing accessories

The miter gauge and wrenches can be stored on the
left side of the base and the rip fence can be stored at
the rear of the base.
Table saw stand
9