Maytag MHW7000AW2 Use & Care Manual page 62

WASHERMAINTENANCE
WASHER CARE (cont.)
Cancellation of Clean Washer Cycle Operation:
If the Clean Washer cycle is canceled by the user after it has
been initiated, it may take up to 30 minutes for the washer
to purge any affresh "" Cleaner, chlorine bleach, or other
chemistry from the wash system and to adequately rinse any
remaining chemistry. The washer door will remain locked until
the cancellation process has been completed. This ensures no
cleaning chemistry will be carried over to the next wash cycle
and reduces the potential for damage to subsequent loads of
laundry or to the washer itself,
Clean Washer Cycle Cancellation Procedure:
1. Touch POWER/CANCEL on the washer once.
2. The washer will begin to drain and rinse away the remaining
cleaning chemistry.
3. The cycle will complete the cancellation process in
approximately 30 minutes or less.
4. The washer then can be used to either repeat the Clean
Washer cycle or to wash laundry using one of the regular
wash cycles selected by the user.
Cleaning the Dispensers
After a period of using your washer, you may find some residue
buildup in the washer's dispensers. To remove residue from the
dispensers, remove the drawer and wipe the surfaces with a
damp cloth and towel dry either before or after you run the Clean
Washer cycle, Use an all-purpose surface cleaner, if needed,
IMPORTANT: Dispenser is not dishwasher safe,
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe up any spills,
Occasionally wipe the outside of your washer to help keep it
looking new, Use mild soap and water,
IMPORTANT: To avoid damaging the washer's finish, do not use
abrasive products,
CLEAN WASHER CYCLE REMINDER
The Clean Washer LED will flash _ JJJ ........
at the end of a wash cycle when _ -%'-
the washer has run 30 wash "_i_an washer
w_th _r_
cycles. This is a reminder to run
the Clean Washer cycle.
If the Clean Washer cycle is not turned on, the LED will stop
flashing at the end of a wash cycle after running 3 more regular
wash cycles. After 30 more wash cycles are completed, the
Clean Washer LED will again flash at the end of a wash cycle as
a reminder.
tf "_
REMOVING THE DISPENSER
To remove:
1. Pull dispenser drawer out until it stops.
2. Press down on the release tab and pull straight out to
remove the dispenser.
"\.",.,,
3. Lift off cover panel by
pulling straight up.
To replace:
1. Slide cover panel back
onto posts on dispenser,
2. Align edges of dispenser
with guides in washer,
then slide dispenser
back into slot.
14