Advertisement
3. Vacuuming
IMPORTANT: Always remove the
power plug from the wall outlet
before assembling, servicing or removing
accessories.
IMPORTANT: Only the red power
button should be "ON" when the
machine is in dry vacuuming mode. The
green pump button should be "OFF".
1. Unclip Container Release Clips (A) on both
sides of machine (Fig.3/1).
A
Fig.3/1
2. Remove the motor top from the unit, turn
on its side and remove the float housing
in an anti-clockwise direction to unscrew
(Fig.3/2).
Fig.3/2
3. Remove the solution connector tube by
turning anticlockwise by 90 degrees. Store
in a safe place (Fig.3/3).
Fig.3/3
4
4. Fit the plug to the solution intake port
(Fig.3/4).
Fig.3/4
Lift out and remove the clean water solution
tank. Store safely away (Fig.3/5).
Fig.3/5
Fit the pleated pre-motor filter by pushing
and lightly twisting the filter on the motor top
(Fig.3/6).
Fig.3/6
4. Wrap Solution Tube (A) around Hose (B).
Ensure that the solution tube is wrapped
loosely enough to allow the solution to flow
freely through the tube (Fig.7/4).
B
A
Fig.7/4
5. After wrapping the tube around the hose,
affix Solution Tube (A) to Hose (B) using
Clips provided (C) to hold it in place
(Fig.7/5).
A
B
C
Fig.7/5
6. Push the second extension tube into the
wash head to be used and push the end
of the solution tube onto the connection
port on the Wash Head / Upholstery Tool
(Fig.7/6).
Fig.7/6
8. Usage
1. Plug in machine to power supply.
2. Press the red button to turn on the power.
3. Press the green button to activate the pump.
Washing Carpets
1. On the Fibreflow wash head ensure that
the rocker switch (A) is towards the back
of the head to allow water to flow through
the head (Fig.8/1).
A
A
Fig.8/1
2. With the solution flowing, wash a section
of carpet approx 3 metres x 3 metres by
Fig.8/1
pushing the wash head backwards and
forwards over the area.
3. Stop the solution flow by moving the rocker
switch (A) to the forward position on the
Fibreflow wash head. This will prevent water
flow, allowing excess water to be removed
from the section just washed (Fig.8/2).
A
A
Fig.8/2
Fig.8/2
4. To wash the next section of carpet, repeat
steps 1 to 3. Continue until the area is
washed.
5. When clean water reservoir is empty, solution
will stop flowing through the wash head and
the pump will make a 'sound' due to sucking
air. Refill the water reservoir with clean water
and Vax Carpet Cleaner. Be sure to empty
the dirty water recovery bucket at this time.
6. If the dirty water recovery bucket becomes
full, the 'sound' your Vax makes will change
and suction will drop. Time to empty it!
Failure to do so will activate the float which,
with continued use, will cause the machine
to overheat.
9
Advertisement
