LG WM3250HRA Owner's Manual page 12

12
INSTALLATION INSTRUCTIONS
Checking and choosing fhe proper Iocafion
Install the washing machine on a solid floor that is strong and
rigid enough to support the weight of the washing machine,
even when fully loaded, without flexing or bouncing. If the
floor has too much flex, you may need to reinforce it to make
it more rigid If the floor is not solid, it may cause severe
vibration and noise
2
3
Clean the floor before installation.
- Make sure to select solid and smooth ground
Two or more people are needed for moving and unpacking
the washing machine
Allow for sufficient space between the walls and the
washing machine for installation.
You must allow sufficient space for water lines, the drain line,
and airflow.
@ NOTE ...... _,
, Be sure to allow for wall, door, or floor moldings that i
_. may increase the required clearances i
_@ NOTE
• The floor must be strong and rigid enough to support the
weight of the washer, when fully loaded, without flexing
or bouncing. If your floor has too much flex,
you may need to reinforce it to make it more rigid
A floor that is adequate for a topqoading washer may not
be rigid enough for a front loading washer, due to the
difference in the spin speed and direction If the floor is
not solid, your washer may vibrate and you may hear and
feel the vibration throughout your house.
• Before installing the washer, make sure the floor is clean,
dry and free of dust, dirt, water and oils so the washer
feet can not slide easily. Leveling feet that can move or
slide on the floor can contribute to excess vibration and
noise due to poor contact with the floor
• If a drip pan must be used, take extra care to follow the
instructions provided with the drip pan and make sure
the leveling feet are adjusted for firm and even contact
with the pan Use of drip pans and failure to propedy
level the machine may result in increased vibration and
noise during operation
I_ 293/4"
(75.6 cm)
77V_ "
196i8 °m)
_" oI_,_,_ _7" ,,,4 I_"
,-@ NOTE
" Refer to the instructions packaged with the optional
PEDESTAL or STACKING KIT before installing with a
PEDESTAL or a STACKING KIT.