GE GTUP240EM4WW Installation Instructions Manual page 11

Installation instructions
[_]MOBILE OR MANUFACTURED HOME
INSTALLATION
. Installation MUSTconform to the MANUFACTUREDHOME
CONSTRUCTION& SAFETY STANDARD,TITLE 24, PART
32-80 or, when such standard is not applicable, with
AMERICAN NATIONAL STANDARD FOR MOBILE HOME,
ANSl/NFPA NO. 501B.
. The appliance MUST be vented to the outdoors with
the termination securely fastened to the mobile home
structure,
. The vent MUST NOT be terminated beneath a mobile or
manufactured home.
. The vent duct material MUST BE METAL.
• KIT14-D346-33 MUSTbe usedto attach the appliance securely
to the structure.
• The vent MUSTNOTbe connected to any other duct, vent, or
chimney.
. Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
. See section 2 for electrical connection information.
[i-0-IALCOVE OR CLOSET INSTALLATION
. If your appliance is approved for installation in an alcove
or closet, it will be stated on a label on the appliance
back.
. TO PREVENT LARGEAMOUNTS OF LINTAND MOISTURE
FROMACCUMULATINGAND TO MAINTAIN DRYING
EFFICIENCY, THIS MACHINEMUSTBE EXHAUSTED
OUTDOORS.
. Do not install this appliance with less than the minimum
clearances shown above.
CONSIDERATION MUST BE GIVEN TO PROVIDE
ADEQUATE CLEARANCES FOR INSTALLATION AND
SERVICE.
AWARNING: DoNOT I NSTALL THIS
APPLIANCE IN A CLOSETWITH A SOLID DOOR.
DOOR VENTILATION OPENING (27" MODELS)
A minimum of 120 square inches of opening, equally divided
at top and bottom, is required. Air openings are required to
be unobstructed when a door is installed. A Iouvered door
with equivalent air openings for the full length of the door
is acceptable.
When louvers or registers are placed in door openings, the
free air openings of the louvers or registers must equal 120
square inches.
DOOR VENTILATION OPENING (24" MODELS)
27" Model
I Sq. In.
/_0 /
li: Iit qn
A minimum of 72 square inches of opening is required. Air
openings are required to be unobstructed when a door is
installed. A Iouvered door with equivalent air openings for
the full length of the door is acceptable.
When louvers or registers are placed in door openings, the
free air openings of the louvers or registers must equal 72
square inches.
24,,Model__ Sqln
/Ill ', _Sq .In.
[n7BATHROOM OR BEDROOM INSTALLATION
. The appliance MUST be vented to the outdoors. See
EXHAUSTINFORMATION section 3 & 4.
, The installation must conform with local codes or, in the
absence of local codes, with the NATIONAL ELECTRICAL
CODE,ANSI/NFPA NO. 70.
11