Q: How Do I Enable And Configure Sequence Mode - Lorex LH110 series Faq

If you select "Enable", and want to use your own e-mail server:
1 Configure the following:
• SSL: Select ON/OFF to enable/disable Secure Socket Layer protocol
• SMTP Port: Enter your SMTP port.
• SMTP Server: Enter your SMTP Server.
• Sender: Enter the sender e-mail address. This can be any address of your choice.
• Password: Enter your e-mail server's password.
• Receiver: Enter the recipient's e-mail address.
• Interval: Enter the interval the DVR waits before sending a new e-mail notification. For
example, if you select a 3 minute interval, the DVR will send out e-mail notifications every 3
minutes until the DVR stops detecting motion/alarm. The DVR will only send out notifications
when it detects motion/alarm triggers.
2 Click Apply to save your settings.

Q: How do I enable and configure sequence mode?

A: In sequence (SEQ) mode, the display automatically switches between a full-screen view
of each of your cameras every few seconds.
To enable Sequence mode:
• Right-click and select Start SEQ.
To disable Sequence mode:
• Right-click and select Stop SEQ.
To change the time each channel will display in sequence mode (Sequence Dwell Time):
1 Right-click and select Main Menu.
2 Click Advance; then click A/V Setup. The Audio Video Setup window appears.
4/8 Channel
3 Under SEQ Dwell Time (4 or 8 channel) or SEQ Time (16 channel), enter the number of
seconds you would like each camera to display for before switching.
4 Click Apply to save your changes. Then, click right-click until you have exited all menus.

Copyright 2013 Lorex Technology Inc.
16 Channel
6