Troubleshooting - NordicTrack C2270 User Manual

Hide thumbs Also See for C2270:
Table of Contents

Advertisement

TROUBLESHOOTING
Most treadmill
problems
can be solved by following
the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance
is needed, please call our Customer
Service Department
toll=
free at 1=888-825=2588, Monday through
Friday, 6 a.m. until 6 p.m. Mountain Time (excluding
holidays).
PROBLEM:
The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 11. Important: The treadmill is not com-
patible with GFCl-equipped
outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
PROBLEM:
C.
Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch pro-
trudes as shown, the circuit breaker has tripped. To
reset the circuit breaker, wait for five minutes and
then press the switch to the reset position.
The power turns off during
use
Tripped
Reset
SOLUTION:
a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch to the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call our Customer Service Department, toll-free.
PROBLEM:
The displays
of the console do not function
properly
SOLUTION:
a. Remove the key from the console and UNPLUG THE
POWER CORD. Carefully lower the Uprights (85).
Remove the two indicated Screws (7). A phillips
screwdriver with an 8" shaft is needed.
a
i
:-_7
b. Raise the Uprights (85) to the vertical position.
Remove the three Screws (7) from the Hood (33), and
carefully pivot the Hood off.
33
3O

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

C2270 ntl12950

Table of Contents