Washer Maintenance - Amana NTW4611BQ1 Use And Care Manual

7, Select LOAD SIZE
LOAD SIZE
small medium
%,,, . .... d
Select the Load Size setting most suitable for your load. Small
will add a low amount of water for smaller loads and Large
will add the most amount of water for large or bulky loads.
Garments need to move freely.
8, Select WASH TEMPERATURE
WASH TEMPERATURE
aH co_d rinses
cool warm
co_d co_d
co_d hot
cow co_d
Once you select a cycle, select the desired temperature by
turning the Wash Temperature knob to the appropriate setting
based on your load. All rinses are cold.
NOTE: Always read and follow fabric care label instructions to
avoid damage to your garments.
Hot
Some cold water is added to save Whites and pastels
energy. This will be cooler than Durable garments
your hot water heater setting. Heaw soils
Warm
Some c old water wi,beadded, so Bright colors
cool iii
Warm water may be added to :::Colors that bleed
assist in soil removal and to help :: or fade
cold ::
This is the temperature from your :::Dark colors that
faucet. If your tap cold water is bleed or fade
very cold, warm water may be Light soils
added to assist in soil removal
and help dissolve detergent.
8
9, Select options, if desired (on some
models)
FABRIC SOFTENER
no yes
q _F
If you are using fabric softener, be sure to set the Fabric
Softener option knob to YES.
Press START/PAUSE/U NLOCK
LID to begin wash cycle
PAUSE/
UNLOCK L_D
0
CANCEL ,,o_o _s_c
Press the START/Pause/Unlock Lid button to start the wash
cycle. When the cycle has finished, the CYCLE COMPLETE
indicator will light. Promptly remove garments after cycle has
completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock Lid; the lid will unlock once
the washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/Pause/Unlock Lid again to restart
the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
WASHER MAINTENANCE
f WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the
"Installation Instructions" for more information.