Crosley CFD27WIPW3 Use & Care Manual page 7

Leveling Freezer Drawer (if necessary)
To level the freezer drawer:
1
2
Check gasket seal around top, bottom, and sides of freezer drawer.
Remove Hex
Head Drawer
Screw
If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each
side) to allow drawer to rotate.
Remove Hex
Head Drawer
screw
Remove Hex
Head Drawer
Screw
Remove Hex
Head Drawer
Screw
Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by
the sides in the center (B). Be careful not
to rotate the drawer.
Push
Against
Freezer
Drawer
I
L_=
=
BI
4 Tighten four drawer screws. 1
5 Recheck gasket seal.
Level Refrigerator & Adjust Doors 2
(if necessary)
Guidelines for final positioning of your
refrigerator:
= All four corners of the cabinet must rest
firmly on the floor.
The sides should tilt 1/4inch (6 mm) from 3
front to back (to ensure that doors close
and seal properly).
Doors should align with each other and be
level.
Most of these conditions can be met by
raising or lowering the adjustable front
rollers.
To level the cabinet using the front
rollers;
Slightly open freezer drawer. Lift the
toe grille and gently pull forward (see
illustration).
You can raise or lower each door. Use
a 3/8 inch socket wrench to turn the
adjustment screws (one per side).
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
counterclockwise.
Ensure both doors are bind-free with their
seals touching the cabinet on all four sides
and that cabinet is stable.