Crosley CFD27WIPW3 Use & Care Manual page 17

CONTROLS
Options May Vary
Used to enter and exit the
options menu and make
selections.
exit
Toggles the opbons and run
modes.
control
locked
quick
freeze on
off
While in the locked state,
you will not be able to
change any settings on the
display nor dispense _ce and
water, The "Control Locked"
indicator will flash and an
audible warning tone is
played.
Acbvates a faster rate for
freezing food and increases
ice producbon in the freezer.
Deactivates after 12 hours.
ice maker
on off
display 0
on off _
refrigerator
ternp
Toggles the ice maker "ON"
or "OFF". In the "Ice Off"
state, indicator will blink
when ice is dispensed.
Toggles the temperature
d_splays On and Off.
Allows the temperature set-
points to be adjusted. Control
temperatures range from
+33 ° F! +1 ° C to +47 ° F /
+8 ° C.
freezer
temp
Allows the temperature
set-points to be adjusted.
Control temperatures range
from-6 °F/-21 °Cto+6 °F
/ -15 o C.
Toggles display from
Fahrenheit to Celsius.
light Toggles dispenser light On
and Off.
power off
water filter
Press and hold for three
seconds to turn off the
cooling system. It also turns
off the ,ce maker and all
dispenser functions. The
display will read "power off"
Displays the current status of
the water filter (Good, Order,
or Replace). To reset the filter
status to "Good", press and
hold the "set" key for three
seconds.
air filter
default
settings
set (+ or -)
water
cube
crush
Displays the current status of
the air filter (Good, Order, or
Replace). To reset the filter
status to "Good'; press and
hold the "set" key for three
seconds.
While in the default opbon,
press and hold the set key
for three seconds to reset a!l
refrigerator setbngs to their
factory default setbngs.
Selects the current menu
selection option.
Press the "water" key
to select water. A green
indicator hght wil! be
illuminated above the acbve
feature.
Pressthe "cube" key to
select cubed ice. A green
indicator light will be
illuminated above the active
feature.
Press the "crush" key
to select crushed ice. A
green indicator hght will be
_llummated above the acbve
feature.
Setting cooling temperatures
(options may vary)
1_ NOTE
When you first power on the refrigerator,
the temperature dBplays 0° F and 37 ° E
After a few seconds, both of the displays will
switch to "HI". The displays will conbnue to
show "HI" for 20 m_nutes. After 20 minutes,
the High Temp alarm will sound and both
displays wdl show the actual temperature.
Plus (+) and Minus (-) indicators are
located on the right side of the control
panel.
Press the + or - indicator to adjust the
temperature to the desired setbng.
17