Advertisement
when the reset button is pushed.
Overheating
may be caused by
misaligned
parts or a dull blade or
undersized extensing cord. inspect
your saw for proper setup before
using it again.
USING THE DUST PORT (FIG. NN)
[A wARNING
]
To prevent fire hazard, clean and
remove sawdust
from under the
saw frequently.
To prevent sawdust buildup inside the
saw housing, attach a vacuum hose (1)
(hose is not included) to the dust
port (2) at the rear of the table saw. DO
NOT operate the saw with the hose in
place unless the vacuum is turned on.
Fig. NN
1
2
USING THE TABLE EXTENSION
(FIG. OO)
NOTE: Use the scale on the front rail
for rip cuts up to 12 in. For rip cuts from
12 in, to 24-1/2 in,, follow the below
instructions,
1, Release the extension
cam locking
levers (1) in the front of table,
2, Slide the table extension (2) out until
the correct measurement is displayed
on the tube scale,
3, Tighten the extension
cam locking
levers (1),
Fig. O0
CUTTING OPERATIONS
There are two basic types of cuts: rip-
ping and crosscutting.
Ripping is cut-
ting along the length and the grain of
the workpiece. Crosscutting is cutting
either across the width or across the
grain of the workpiece. (It is not safe to
rip or crosscut by freehand).
Ripping requires the use of the rip
fence, and crosscutting requires the
miter gauge. NEVER USE THE TWO
AT THE SAME TIME.
NOTE: Apply a coat of automobile wax
to the table. Wipe all parts thoroughly
with a clean dry cloth, This will reduce
friction when pushing the workpiece,
wAR.I.G ]
Before using the saw each time,
check the following:
1. The blade is tightened
to the
arbor.
2. The bevel lock knob is tightened.
3. If ripping,
make sure the fence
is locked in the position
and
is parallel to the miter gauge
groove.
4. The blade guard is in place and
working
properly.
5. Safety glasses are worn.
The failure to adhere to these com-
mon safety rules, and those printed
in this manual, can greatly increase
the likelihood
of injury.
35
:,
Advertisement
