Advertisement
Fig.N
1
iNSTALLiNG THE HANDWHEEL
HANDLE (FIG. O)
NOTE: UP-DOWN is printed on this
handwheel.
1. Thread the handwheel handle (1)
into the handwheel hole (2), and
then tighten.
Fig. 0
/
I
iNSTALLiNG THE BLADE
(FIG. P, Q, R)
WAR.I.G }
To avoid injury from an accidental
start, make sure the switch
is in
the OFF position
and the plug is
not connected
to the power source
outlet.
1. Remove the table insert (1) by
inserting your finger into the
opening (2) and pulling up. Raise
the blade to the maximum height
by turning the blade elevation
handwheel clockwise. (Fig. P)
Fig. P
1
2. Remove the arbor nut (3) and outer
blade flange (4). (Fig. Q)
Fig. Q
6
--_
--
Advertisement
