Advertisement
STORAGE
(FIG. G, H, I, J, K, L, M, N)
Rip fence and miter gauge (Fig. G)
The storage for the rip fence (1) and
miter gauge (2) are built into the base
and are located on the left side of the
saw housing.
Fig. G
Blade and blade wrench (Fig. I)
The storage for the blade (1) and blade
wrench is located on the right side of
the saw housing.
1. Loosen and remove the knob (2),
place the blade (1) and blade
wrench (3) on to the arbor. Replace
the knob (2) and tighten.
Fig. I
Push stick (Fig. H)
The storage for the push stick (1) is
located on the left side of the saw
housing.
Fig. H
o
2
Installing
the storage
of blade guard
and anti-kickback
pawls (Fig. J)
1. Attach the retaining clip (1) to right
side of the stand (2) using two
screws (3). Tighten screws using a
screwdriver.
2. Attach the set plate (4) to the right
side of the stand (2) using two
screws (3). Tighten screws securely
using a screwdriver.
Fig. J
4
Advertisement
