Advertisement
I,A WARNING
1
For your safety, never connect
plug
to power source
receptacle
until all
assembly
and adjustment
steps are
complete,
and you have read and
understood
the safety instructions.
ASSEMBLING
THE WHEELS TO
STAND (FIG. A)
1. Attach one wheel (1) to the leg using
the long hex bolt (2), the two flat
washers (3) and the lock nut (4), as
shown in Fig. A. Tighten the lock
nut (4) using a 14 mm wrench.
2. Repeat above step for the other
wheel to the other leg.
Fig. A
4
3
3
2
Right Side
1
[A wARNING]
To properly
lock the stand, the
locking
handle MUST be secured
in
the slot on this cover plate (4).
Fig. C
SETTING UP THE STAND
(FIG. B, C, D)
1. Lift up the stand to upright position
as shown in Fig. B.
2. Unfold the left side set leg (1) by
Fig. D
releasing the locking levers (2) from
slot A to slot B, then rest the left side
of the stand onto the floor.
3. Release the hook (3) from the stop
screw.
4. Lift the right side frame of stand
slowly by the handle upward to its
highest position; the stand locking
handle (5) will rebound to left
automatically
to secure the stand,
locking handle
release direction
SETTING UP
d>
Advertisement
