Advertisement
RiViNG KNIFEASSEMBLY
{AWARNING
]
o To avoid injury from an
accidental
start, make sure the
switch is in the OFF position
and
the plug is disconnected
from the
power source outlet.
= Never operate this saw without
the riving knife in the correct
position.
installing the riving knife assembly
(Fig. S, T, U)
NOTE: The table insert should be
removed and the blade raised to its
highest position before proceeding.
1. Loosen the bevel lock knob (1). Turn
and move the handwheei (2) to 45 °
on the bevel scale, and then tighten
the bevel lock knob (1).
Fig. S
2
1
Z
,_ WARNING
i
o DO NOT operate saw if riving
knife is not locked in the through=
cut slot (A) or non through=cut
position slot (B).
= To avoid the lock lever
interferring the table insert, after
tighten the riving
knife, position
the riving knife locking knob (3)
pointing downward
before
using
saw. Failure to maintain
a level
insert can result in serious injury
to the operator. (Fig. U)
o The riving
knife locking knob (3)
can be pulled out to allow it to
be turned
to a new position
downward.
(Fig. U)
Fig. T
4_
_\
.........
=-
6
2. Loosen the riving knife locking
knob (3) counterclockwise.
3. insert the riving knife (4) into the
space between the mounting
bracket and the set plate (5) located
behind the saw blade (6). Ensure the
lock pin of the riving knife locking
knob (3) engages with one of the
slots (A, B) on the riving knife (4).
4. Tighten riving knife locking knob (3)
clockwise. NOTE: The riving knife
has two positions, the high position
for all through cuts and the low
position for all non-through cuts.
5. Loosen the bevel lock knob (1) and
S
return the blade to 0° and lock,
(Fig, S)
25
:_
Advertisement
