Time And Status Display - Kenmore 796.31412310 Use & Care Manual

TIME AND STATUS DISPLAY
The time and status display shows the estimated time remaining and cycle progress.
STATUS
O @ @ @ @ @
LOAD SOAK WASH RINSE SPIN
SENSING
O CYCLE STATUS INDICATOR
These LEDs will illuminate when a cycle is selected
to indicate which stages will run. When a cycle
is running, the LED will blink for the active stage.
Once a stage is complete, the LED will turn off. If a
cycle is paused, the active LED will stop blinking.
O
ESTIMATED TIME REMAINING
When a cycle is selected, the default time for
that cycle is displayed. This time will change as
modifiers or options are selected. Once the START/
PAUSE button is pressed, the washer will measure
the size of the load. The estimated time may
change once the load size has been measured.
NOTE: The time shown is only an estimate. This
time is based on normal operating conditions. Sev-
eral external factors (load size, room temperature,
incoming water temperature, etc.) can affect the
actual time.
19