Time And Status Display - Kenmore 796.41282310 Use & Care Manual

TIME AND STATUS DISPLAY
The time and status display shows the estimated time remaining, cycle progress, and door lock status.
IWoshTom0 ISPioSPoo } Soi Lovo [Chino l
All Cold Rlnsos
O ESTIMATED TIME REMAINING
When the START/PAUSE button is pressed, the wash-
er win automatically detect the load size for cycles
that use load sensing. The control will then optimize
the wash and rinse times, based on the selected
cycle, modifiers and options. When the load size
has been determined, the display will change from
dashes (- - -) to the estimated time for that cycle.
For non-load sensing cycles, the estimated time will
display when the cycle is selected.
NOTE:
• The time shown is only an estimate. For example,
the time displayed may pause for a period of time
while the machine is heating the water or balanc-
ing the load. Under certain conditions, the machine
can pause for extended periods of time.
• Estimated time is based on normal operating con-
ditions. Several external factors (load size, room
temperature, incoming water temperature, etc.) also
affect the length of estimated time vs. actual time.
O LOAD-SENSING INDICATOR
At the beginning of cycles that use the load sensing
feature, the LOAD SENSING light will blink while the
load size is being measured. Once the size has been
determined, the control adjusts the cycle for opti-
mum performance. Estimated time remaining will not
display until the toad size has been determined, and
may be different for each load.
O
O
CYCLE STATUS INDICATOR
These status LEDs illuminate to indicate which stage
of the cycle is currently running. A blinking light indi-
cates the active stage of the cycle. When that stage
is complete, the light wilt remain steady.
DOOR LOCI( INDICATOR
Indicates that the door is locked. The washer door
will lock while the washer is operating. The door can
be unlocked by pressing START/PAUSE to pause the
washer.
NOTE:
• If the temperature in the washer is too high, the
door cannot be unlocked until the washer has
cooled.
• If the water level is too high, the door will not
unlock. To drain the water, press POWER, then
press the SPIN SPEED button without selecting a
cycle. Press START/PAUSE and the water will drain
and the clothes will spin out. Do not try to force the
door open, as it will damage the door.
19