Initial Setup - Furuno TZTL12F Installation Manual

3.3

Initial Setup

This section shows you how to set your system according to the sensors you have
connected.
Note: Some units are set to metric in this section, actual setting ranges vary
depending on the unit of measurement set in the [Units] menu.
1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Settings] to show the [Settings] menu.
3. Drag the main menu, then tap [Initial Setup] to show the [Initial Setup] menu.
4. Referring to the tables on the following pages, set your equipment.
[Initial Setup] menu - [GPS POSITION]
Menu item
[Longitudinal (from
bow]
[Lateral (-Port)]
Menu item
[Boat Length]
[Size of Static Icon]
[Depth Display]
[Transducer Draft]
[Keel Draft]
[Graphic Instruments
Setup]
[Engine & Tank
Automatic Setup]
[Engine & Tank
Manual Setup]
Description
Referring to the figure on the
right, enter the GPS antenna
positioning bow-stern
(Longitudinal) and
port-starboard (Lateral)
position from the origin.
Description
Set the length of your boat.
Set the size of static (such as own ship)
icons.
Select the start point for depth measure-
ment.
Set the transducer draft.
Set the keel draft.
See "[Initial Setup] menu - [GRAPHIC INSTRUMENTS
SETUP]" on page 3-8.
See "[Initial Setup] menu - [Engine & Tank Automatic Setup]" on page 3-9.
See "[Initial Setup] menu - [Engine & Tank Manual Setup]" on page 3-9.
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
0 (m) to 999 (m)
-99 (m) to +99 (m)
Origin Origin
Port-side is negative,
Starboard-side is positive.
Options (setting range)
0 (m) to 999 (m)
50 to 150
[Under Keel],
[Under Sea Level]
0.0 (m) to 99.9 (m)
0.0 (m) to 99.9 (m
3-5