How To Set Up The Radar - Furuno TZTL12F Installation Manual

[Initial Setup] menu - [Engine & Tank Automatic Setup]
The TZTL will automatically detect engines and tanks connected to the same network.
This is the recommended method for setting up engines and tanks.
[Initial Setup] menu - [Engine & Tank Manual Setup]
The manual set up method should only be used if the automatic setup did not correctly
detect your engines or tanks.
Menu Item
[Nickname]
[Used For Propulsion]
[Reset]
3.4

How to Set Up the Radar

1. Tap the [Home] icon to show the home screen and display mode settings.
2. Tap [Radar] from the [Settings] menu.
3. Tap [Radar Source], then select the appropriate radar sensor.
Note: If a DRS sensor is connected but does not appear in the [Radar Source] list,
close the list and open it again. The name of the DRS sensor should appear with
a check mark, as in the example below.
4. Drag the [Radar] menu display the menu item [Radar Initial Setup], then tap
[Radar Initial Setup].
5. Referring to the tables on the following pages, set up the radar.
Fuel
Fuel2
Fuel3
Fuel4
Description
Change the nickname for the engine or tank.
Select which engine/tank is used to
calculate the distance which may be
traveled using the remaining fuel. [ON] uses
the engine/tank for calculations, [OFF]
ignores the engine/tank.
Resets the engine/tank details to default.
3. HOW TO SET UP THE EQUIPMENT
Options (setting range)
[ON], [OFF]
3-9