Initial Setup Menu - Furuno TZTL12F Operator's Manual

13.3

Initial Setup Menu

The [Initial Setup] menu, which is mainly for use by the installer of the equipment, sets
up the system according to the sensors connected. These adjustments require some
knowledge of marine electronics equipment. If you are unsure of your abilities, have a
qualified marine electronics technician make the adjustments. Inadequate adjustment
can affect performance.
GPS POSITION section
Menu item
[Longitudinal (from
bow]
[Lateral GPS Position
(-Port)]
BOAT INFORMATION section
Menu item
[Boat Length]
[Size of Static Icon]
[Depth Display]
[Transducer Draft]
[Keel Draft]
[Graphic Instruments
Setup]
[Engine & Tank Setup]
Graphic Instruments Setup:
Menu Item
[Maximum Boat Speed]
[Maximum Wind Speed]
Menu Item
[Minimum Depth]
[Maximum Depth]
Description
Enter the GPS antenna posi-
tioning bow-stern (Longitudi-
nal) and port-starboard
(Lateral) position from the
origin.
Description
Set the length of your boat.
Set the size of static (such as own ship)
icons.
Select the start point for depth measure-
ment.
Set the transducer draft.
Set the keel draft.
Set the graphic instruments display. See the description below.
Set the engine and tank displays. See "Engine & Tank Setup" on the next
page.
Description
Set the transducer's maximum detectable
speed.
Set the transducer's maximum detectable
speed.
[Graphic Instruments Setup] - [Depth]
Description
Set the transducer's minimum detectable
depth.
Set the transducer's maximum detectable
depth.
13. OTHER FUNCTIONS
Options (setting range)
0 m to 999 m
-99 m to +9 m
Origin Origin
Options (setting range)
0.0 m to 999 m
50 to 150
[Under Keel], [Under Sea Lev-
el]
0.0 m to 99.9 m
0.0 m to 99.9 m
Options (setting range)
1 kn to 99 kn
1 kn to 99 kn
Options (setting range)
1 m to 19 m
20 m to 2000 m
13-3