Factory Reset; Device Data Model Support; Oui And Product Class - Mitel 6863i Configuration Manual

Factory Reset

The purpose of a factory reset is to restore the configuration to default when it is requested by the ACS server. From the
ACS server, make a "factory reset" request. This will set all the parameters to the default value.
Note:
A factory reset will result in the phone clearing out all configured parameters, including the TR-069 configured settings.

Device Data Model Support

For this release, the phones support only the configuration parameters listed in the section,
port" on page 2, for remote management through the TR-069 Protocol. Some ACSs (e.g. a specific home management
device) requires a vendor-specific device data model in XML format before the IP phones can connect to it. See
B - XML Data Model Schema"
As defined in this data structure, some parameters have write privileges and can be changed remotely (e.g. DNSServer).
However, you may have to reboot the phone in order for the change to take effect.

OUI and Product Class

The above data structure is common across all the TR-069 supported Mitel SIP phones. The table below summarizes the
supported phones and their corresponding OUI and Product Class.
Supported Mitel Models
6863i
6865i
6867i
6869i
41-001562-00 REV00 – 10.2014
on page B-1 for an example of an XML data model schema.
OUI
00085D
00085D
00085D
00085D
TR-069 Protocol Support
"TR-069 Functionality Sup-
Product Class
6863i
6865i
6867i
6869i
"Appendix
13