38
en | Faults and Tamper Conditions
13
Faults and Tamper Conditions
Whenever a system fault or tamper condition occurs, the FAULT
indicator flashes and the keypad beeps.
Notice!
This operation is only possible in disarmed status.
13.1
System Fault or Tamper Analysis Mode via
Text Keypad
To display the fault or tamper analysis for describing a system
fault or tamper condition, perform the following steps:
1.
2.
3.
13.2
System Fault or Tamper Analysis Mode via
LED/LCD Keypad
To display faults and tampers via a LED/LCD keypad, perform
the following steps:
1.
2.
3.
2015.05 | 04 | F.01U.295.569
Enter your code + [2] [1] and press [#].
The system beeps twice and the fault or tamper conditions
are displayed.
Use [▲] and [▼] to display all fault or tamper conditions.
Press [#] to exit.
Enter your code + [2] [1] and press [#].
The system beeps twice. The FAULT indicator is
extinguished and the STAY and AWAY indicators flash. One
of the number indicators is lit. Example: 2.
Enter the number that is lit in the system. Example: 2.
One of the number indicators is lit. Example: 1.
Repeat step 2 until there is no number lit anymore.
Bosch Sicherheitsysteme GmbH
AMAX panel