Troubleshooting - Vermont Castings WDV500NTSCSB Installation And Operating Instructions Manual

WDV Series Gas Fireplace
USING THE MOUNTING BASE
The transmitter comes with a mounting base which allows
you to hang the transmitter on the wall.
1. Secure the mounting base on the wall with supplied
screws. For best viewing
angle, make it the same
height as your eyes.
2. Hang the transmitter on the
hook of the mounting base,
then push down so the
transmitter is flush to the
mounting base.

TROUBLESHOOTING

Symptom
Battery icon on LCD on transmitter
LCD display is blank
LCD display shows "funny" display
Appliance does not come on
Blower is not on after the fireplace
is turned on
40
SIGNATURE COMMAND SYSTEM OPERATION
Figure 56
FP2674
mounting base
Causes
Low Battery
Low Battery
Low Battery
The transmitter did not match with the
receiver.
Transmitter measures temperature
exceeding 99°F and shows "HI" on LCD.
Distance between the transmitter and
receiver is more than 30 feet.
Blower setting is off.
Blower delay setting is set too high.
Action
Replace batteries. Change batter-
ies every 6 months.
Check battery installation or replace
batteries.
Reset the transmitter (see "Reset-
ting the Transmitter" setting)
Make sure the transmitter has
learned to the receiver.
Move transmitter to a cooler place
and wait until temperature drops
below 99°F.
Make sure the opening distance is
less than 30 feet.
Press FAN key to select fan speed
desired.
Press and hold FAN key to set
desired ON/OFF delays. This is
done in minutes.
20306744