Getting Started; Location; Setting Up - BT GRAPHITE 2500 User Manual

Getting started

Location

You need to place your BT Graphite 2500 base within 3 metres of
a mains power socket and 2 metres of the telephone wall socket
so that the cables will reach.
Make sure it is at least 1 metre away from other electrical
appliances to avoid interference.
Your BT Graphite 2500 works by sending radio signals between
the handset and base. The strength of the signal depends on
where you position the base. Putting it as high as possible can
help to provide the best signal.

Setting up

1. Plug the mains power adaptor (item code 052299) into the
power socket marked
the cable behind the retaining clip. Plug the other end into the
mains power wall socket and switch on. The base will come on
and beep and display 00.
It will default to Answer and record mode.
Telephone line cord
(pre-installed).
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp.com
on the back of the base and secure
Mains power adaptor.
WARNING
Do not place your BT Graphite 2500
in the bathroom or other humid
areas.
Handset range
The BT Graphite 2500 has a range of
300 metres outdoors when there is a
clear line of sight between the base
and the handset. Any obstruction
between the base and handset will
reduce the range significantly.
With the base indoors and handset
either indoors or outdoors, the range
will normally be up to 50 metres.
Thick stone walls can severely affect
the range.
Signal strength
The
indicates when you are in range of
the base. When it flashes and you
hear a warning beep, you are out of
range and will need to move closer to
the base.
IMPORTANT
Do not connect the telephone line to
the telephone line wall socket until
the handset is fully charged.
The base station should be
plugged into the mains power
socket at all times.
Cable
retaining
clip
icon on your handset display
6