installation & connection
5. Insert the LAN cable into the large hole made by
removing the projected part of the rubber plug in step
2 above.
6. Remove the sheath with a cable cutter, and align the
cables.
7. Connect the LAN cable with a LAN connector, and
insert it into the LAN tool.
8. Connect the finished cable to the Ethernet port.
if the Lan cable is connected indoors
1. Remove the dome cover and the case.
2. Pull out the rubber plug on the bottom as shown in
the figure.
3. Insert the power cable into the hole, and lay the cable
along the long groove.
4. Connect the power cable with the power terminal
block.
5. Insert the LAN cable into the hole, and connect the
cable with the Ethernet port.
32_ installation & connection