Samsung SND-6084R User Manual page 25

Item
Internal Cover
a
Illumination Sensor
b
Lens
c
IR LED
d
Power Port
e
Test Monitor Out
f
Reset Button
g
Zoom/Focus Control
h
Button
Micro SD Memory
i
Card Compartment
Audio and alarm
j
cable port
Network Port
k
It is a cover to protect the main body.
Detects incoming light to control the IR LED.
Lens for the camera.
These infrared LED's are controlled by the illumination sensor.
Port for power terminal block.
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
T Zoom in (Tele)
W Zoom out (Wide)
N Focusing on a near object (Near)
F Focusing on a far object (Far)
Focus Control Press this button for automatic focus control.
Compartment for the Micro SD memory card.
Plug in the audio and alarm cable to this port to connect with external alarm
device/microphone/speaker.
Used to connect the PoE or Ethernet cable for network connection.
Description
English _25