Samsung SND-6084R User Manual page 17

Item
Internal Cover
a
Illumination Sensor
b
Lens
c
IR LED
d
Zoom/Focus Control
e
Button
Reset Button
f
Test Monitor Out
g
Alarm I/O Port
h
Power Port
i
It is a cover to protect the main body.
Detects incoming light to control the IR LED.
Lens for the camera.
These infrared LED's are controlled by the illumination sensor.
T Zoom in (Tele)
W Zoom out (Wide)
N Focusing on a near object (Near)
F Focusing on a far object (Far)
Focus Control Press this button for automatic focus control.
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
If you reset the camera, the network settings will be adjusted so that
J
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
Used to connect the alarm input sensor or external day/
ALARM IN
night sensor.
ALARM OUT Used to connect the alarm output signal.
GND Common port for alarm output signal.
Port for power terminal block.
Description
English _17