Static Routing - D-Link DSL-500T User Manual

Static Routing

Use Static Routing to specify a route used for data traffic within your Ethernet LAN or to route data on the WAN.
This is used to specify that all packets destined for a particular network or subnet use a predetermined gateway.
Figure 4-6. Static Routing menu
To add a static route to a specific destination IP on the local network, enter a Destination IP address, Netask,
click the Gateway radio button and type in the Gateway's IP address. Click Apply to enter the new static route
in the table below. The route becomes active immediately upon creation.
To add a static route to a specific destination IP on the WAN, click the Connection radio button and choose a
connection from the pull-down menu, then enter a Destination IP address and Netask. Click Apply to enter the
new static route in the table below. The route becomes active immediately upon creation
To remove a static route from the table in the bottom half of the window, choose to Delete it from the table and
click the Apply button. Remember to save the configuration changes.
51