Flame & Temperature Adjustment; Flame Characteristics - Majestic fireplaces LDVR1 Installation Instructions And Homeowner's Manual

LDVR Series Direct Vent Gas Fireplace
43LDVR
1. Place rear log (BD15) on rear bracket
(ensure log is centered and seated
properly to the log support).
2. Place front left log (BD16). Use log's
bottom notch to locate it onto the front
support and just rest on top of the
burner housing tile.
3. Place front right log (BD17). Use log's
bottom notch to locate it onto the front
support and just rest on top of the
burner housing.
4. Place ember material on top of burner.
5. Scatter the ember material over the
tiles on the front area of the burner
housing. (Fig. 44) Do not pack the
ember material. Separate it when
unpacked and keep it in a fluffy and
loose condition for a more realistic
ember effect.
6. Place front center log (B138) on top of
the two small shelves at the front log
support, and between the left and right
logs.
7. Place top center log (BD18) on top of the rear log
using the hole locator under the log and on top of
front right log.
8. Scatter lava rock material round the firebox base.
Flame & Temperature Adjustment
RN/RP & EN/EP Models
For units equipped with "HI/LO" valves the flame
adjustment is accomplished by rotating the "HI/LO"
adjustment knob located near the center of the gas
control valve. (Figs. 45 & 46)
Honeywell Valve
Turn
counterclockwise
to decrease
flame height
Fig. 45 Flame adjustment knob for Honeywell valve.
SIT 820 Valve
Turn
counterclockwise
to increase
flame height
Fig. 46 Flame adjustment knob for SIT valve.
26
FP390
FLAME ADJUSTMENT KNOB
11/21/96
Front
Left
(BD16)
Fig. 44 Correct log placement for 43LDVR.
Turn clockwise
to increase
flame height
Turn clockwise
to decrease
HV102
Honeywell hi/lo knob
flame height
4/5/99 djt
Top Center
(BBD18)
Rear
(BD15)
Lava Rock
Do not place any of the lava rock material
on the burner housing assembly.

Flame Characteristics

It is important to periodically perform a visual check
of the pilot and burner flames. Compare them to the
illustrations. (Figs. 47-48)
If the flame patterns appear abnormal contact a
qualified service provider for service and adjustment.
Fig. 47 Correct pilot flame appearance.
Lava
Rock
Ember Material
Front Center
(B138)
�����
����� ����
����
SIT RN/RP
SIT EN/EP
Front Right
(BD17)
LG434
FP1541
10007317