Ember Material Placement; Lava Rock; Flame & Temperature Adjustment - Majestic fireplaces DVBR36 Homeowner's Installation And Operating Manual

DVBR Series Direct Vent Gas Fireplace
5. Place the front edge of the Left Cover Log on
the front top edge of the burner between the
last two left tines of the grate. Allow the bottom
edge of the log to sit on the hearth. Place the
Right Cover Log between the right two tines
and rest the log up against the front face of the
burner. (Fig. 52)
6. Place the Center Log between the second and
third tines as shown. Place the v-notch on the
left side of the Center Log against the left tine of
the grate. Rest the right side of the Center log
up against the face of the Right Log. (fig. 52)
Figure 53
Left Cross Log
LG392

Ember Material Placement

�����
Separate the ember material into small pieces, roughly
���� ����
1/2" in diameter and place onto the burner in front of
the front logs. Do NOT pack down, leave in fluffy, loose
����
condition for most realistic ember effect.

Lava Rock

The lava rock provided with this fireplace must be placed
on the firebox base around the burner assembly.
Under no circumstances should this lava
rock be placed on any part of the burner
assembly.
Top logs must be placed properly onto
notches.
26
Log Top Right
(DVBR42 ONLY)
Left Front Log
Figure 52
LG391
7. Place the left Cross Log over the pin of the Right
Rear Log and the pin of the Left Log. (Fig. 3)
�����
8. DVBR42 only. Place the Right Cross Log over
the Right Rear Log and the Right Log as shown.
���� ����
(Fig. 53) When positioned correctly, the right rear
flame will come up through the hole in the Right
����
Cross log. Carefully adjust the log as needed to
allow the flame to come through the hole.
Flame & Temperature Adjustment
For fireplaces equipped with Hi/Lo valves, flame adjust-
ment is accomplished by rotating the Hi/Lo adjustment
knob located near the centre of the gas control. (Fig. 54
& 55)
Turn
counterclockwise
to decrease
flame height
Fig. 54 Flame adjustment knob for Honeywell valve.
Turn
counterclockwise
to increase
flame height
Fig. 55 flame adjustment knob for SIT valve.
FP390
FLAME ADJUSTMENT KNOB
11/21/96
Center Log
Left Cover Log
Turn clockwise
to increase
flame height
Turn clockwise
HV102 to decrease
Honeywell hi/lo knob
flame height
4/5/99 djt
Right Cover
Log
HV102
20000584