Table of Contents
Advertisement
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced >
Security Settings > Change Security Settings menu after opening the OSD menu
system. Press MODE/ENTER. The message "INPUT PASSWORD" displays. Enter
the current password.
i. If the password is correct, the OSD menu returns to the Security Settings
page.
Press
not have to enter the password next time when turning on the projector.
Press
the Web Control Lock is released and projector settings can be changed via
the Projector Network Display System.
ii. If the password is incorrect, the password error message displays lasting for
three seconds, and the message "INPUT PASSWORD" displays for your
retry. You can press MENU/EXIT to cancel the change or try another
password.
Though the password function is disabled, you need to keep the old password in hand should you ever need to
re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time. When starting up, the projector automatically searches for
the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On if you want the
projector to automatically search for the signals.
To select the source:
1.
Press SOURCE on the projector or remote
control. A source selection bar displays.
2.
Press
press MODE/ENTER.
Once detected, the selected source information will
display at the corner of the screen for seconds. If
there is multiple equipment connected to the
projector, repeat steps 1-2 to search for another
signal.
•
The brightness level of the projected image will change accordingly
when you switch between different input signals. Data (graphic)
"PC" presentations using mostly static images are generally
brighter than "Video" using mostly moving images (movies).
•
The native display resolution of this projector is in a 4:3
(MX882UST)/16:10 (MW883UST) aspect ratio. For best display
picture results, you should select and use an input signal which
outputs at this resolution. Any other resolutions will be scaled by
the projector depending upon the "aspect ratio" setting, which
may cause some image distortion or loss of picture clarity. See
"Selecting the aspect ratio" on page 29
•
Firewall in the PC must be switched off to allow USB Display to work.
28
Operation
to highlight Power On Lock and press
to highlight Web Control Lock and press
/
until your desired signal is selected and
for details.
/
to select Off. You will
/
to select Off. Now
Advertisement
Table of Contents
