Table of Contents
Advertisement
•
Corner fit correction
•
Surface fit correction
Set up your screen via the QUICK INSTALL hotkey on the remote control. You can
also go to the SYSTEM SETUP: Basic > Projector Installation menu after turning on
the projector. See
Your room layout or personal preference will dictate which installation location you select.
Take into consideration the size and position of your screen, the location of a suitable
power outlet, as well as the location and distance between the projector and the rest of
your equipment.
Obtaining a preferred projected image size
Projection dimensions
a
D
•
Installation distance D is measured from the projector rear side to the wall surface, which is also indicated
on the scale of the wall mount.
•
Projection distance a is measured from the projector rear side to the projection surface.
•
Vertical offset V is measured from the bottom edge of the wall plate to the top edge of screen.
"Using the menus" on page 25
Scale value = D
Thickness of the screen
X
on how to use the OSD menu.
Center
Center
M
W
Positioning your projector
30 mm
Plate height 260 mm
With cover 270 mm
V
Ceiling height (H)
=30mm+ Plate
height +V+h+F
h
F
15
Advertisement
Table of Contents
