Controls & Features - Troy-Bilt 208cc FLEX Operator's Manual

Controls & Features
Attachment Control Lever
Drive Control Lever
Primer
Attachment Control Lever
The attachment control lever is for deploying power to the
various available attachments. See also Figure 4-2.
Handle Adjustment Knobs
Utilize these two knobs to adjust the height and position of the
FLEX™ Power Base's handle assembly. Refer to Installing and
Adjusting the Handle in the Assembly and Setup Section of this
manual for specific instructions regarding adjusting the handle.
Cold Weather/Warm Weather Control
This control is utilized throughout the year. Turn the control to
Winter for Winter operation (below 320F), and Summer (above
320F) for Summer operation.
12
Attachment Control Safety Lock
Fuel Cap
Oil Fill Cap
Recoil Starter
Key
Choke
Figure 4-1
On/Off Switch
Handle Adjustment Knob
Kickstand
Kickstand
The kickstand is utilized to hold the FLEX™ Power Base in an
upright and parked position when there is NO attachment
present. It also locks the attachment to the power base (when in
"Up" position) and unlocks the attachment when placed in the
down position.
Recoil Starter
The recoil starter employs a starter rope and handle used to pull-
start the engine.
4
Cold Weather/Warm
Weather Control