Alcatel-Lucent 1850 TSS-320 Turn-Up And Commissioning Manual page 52

Tests and Measurements
............................................................................................................................................................................................................................................................
Open the SONET loop to check the presence of the TSF alarm on the remote port, as
•
described in the following.
– Select a remote port. From the pop-up menu, select "Configure Ethernet port."
–
– Select the remote port again, open the pop-up menu and select "Ethernet Port
Connect the instrument and check that the alarms (LOS and TSF) disappear.
•
– The alarm signalling is also displayed in the CT main window, by a red circle on
E O
N D
........................................................................................................................................................
CLI Procedure
........................................................................................................................................................................................................................
1
Cross-connect the GbE port (on PIM1GE) to the SONET port via the multiservice PIM
(PIMMS) and the Matrix (MT320)
........................................................................................................................................................................................................................
2
By CT create a number of active VC4-xV (x = 7) on PIMMS, as shown in
"Unprotected, bi-directional cross-connect: concatenated group (VC4-7V) and STM-N
port" (p.
........................................................................................................................................................................................................................
3
Cross-connect the VC4-7V to an SONET port (OC-36), as shown in
"Unprotected, bi-directional cross-connect: concatenated group (VC4-7V) and STM-N
port" (p.
........................................................................................................................................................................................................................
4
Cross-connect the VC4-7V to one port of the 10 x 1 GbE PIM (PIM1GE), as shown in
Chapter
........................................................................................................................................................................................................................
5
Start transmitting at 100% of the available bandwidth
Pattern generator / Error Detector setup
Port type
Auto-negotiation
............................................................................................................................................................................................................................................................
3 - 2 6
In "Ethernet port Configuration" window, select "Configuration" tag and set "Up"
in "Admin. Status" field. Click on "OK."
Properties." Open the "Alarms" tag and check the presence of the TSF alarm (red
square).
the left of the port.
S
F T E P S
4-9).
4-9).
4, "Cross-connection between a local and a remote data port" (p.
Local testing and operating sequence
GbE
ON
Chapter 4,
Chapter 4,
4-12).
PN 8DG08136CAAA
Issue 1 March 2008