The Guidance View - TomTom GO Reference Manual

1. Back button. This button returns the map to an overview of your whole route or, if no route is
planned, moves the map to put your current location at the center.
2. Switch view button. Select the switch view button to change between the map view and the
guidance view.
When in map view, if you are driving, the small compass arrow rotates to show your current
driving direction, with north being up.
Tip: The compass direction you are driving is shown in the switch view button below the small
compass arrow, for example, NE for North East. These compass directions automatically
appear when driving in North America and disappear if you leave North America.
3. Zoom buttons. Select the zoom buttons to zoom in and out.
4. Current location. This symbol shows your current location. Select it to add it to My Places or
search near your current location.
Note: If your GO cannot find your location using GPS or other methods, the symbol appears
gray.
5. Selected location. Press and hold to
button to show options for the location, or select the drive button to plan a route to the loca-
tion.
6. Main Menu button. Select the button to open the Main Menu.
7. Map symbols. Symbols are used on the map to show your destination and your saved places:
Your destination.

Your home location. You can set your home location in

A stop

A location saved in

Select a map symbol to open the pop-up menu, then select the menu button to see a list of
actions you can take.
8. Traffic information. Select the traffic incident to display information about the
9. Your route, if you have
a stop or save changes to your route.
10. Safety cameras on your route. Select a
11. Route bar. The route bar

The guidance view

The guidance view is used to guide you along the route to your destination. The guidance view is
shown when you start driving. You see your current location and details along your route, including
3D buildings in some cities.
Note: 3D buildings in guidance view are not available on all devices.
The guidance view is normally in 3D. To show a 2D map with the map moving in your direction of
travel, change the 2D and 3D default
select a location
on your route.
My Places.
planned a route. Select the route to clear it, change the route type, add
safety camera
is shown when you have planned a route.
settings.
on the map. Select the pop-up menu
to display information about that camera.
16
My Places.
traffic delay.