Table of Contents
Advertisement
➤ D2D
The system has the ability to interface with an XK module through the D2D port.
The advantage to using a D2D interface is that there is less wiring involved in
the installation. Check the XK module installation guide to determine which wires
are not needed, and which options are available.
➤ The control center
The control center position should be discussed with the vehicle's owner prior to
installation. The LED and Valet switch are housed on the control center, so make
sure the customer is satisfied with the location.
➤ Valet® program switch
The valet/program switch is built into the control center.
Important:
user where this switch is lo cat ed and how to disarm the system
with it.
Note: An optional valet switch (p/n #8631) is available if the onboard valet
switch is not used for the installation.
When installing the external valet switch ensure that the location has sufficient
clearance to the rear. The switch should be well hidden. It should be placed so
pas sen gers or stored items (such as in a glove box or center console) cannot
accidentally hit it. The switch fits into a 9/32-inch hole.
➤ Status LED
The status LED is built into the control center. An optional LED (p/n 8634) is
available if the onboard LED will not be used for the install. The LED fits into a
9/32-inch hole.
8
Valet switch
When the vehicle is delivered, please show the
LED
© 2008 Directed Electronics. All rights reserved.
Hide quick links:
Advertisement
Table of Contents
