Clifford 1.2 Installation Manual page 19

Remote start keyless entry

Hide thumbs Also See for 1.2:

Table of Contents

H1/11

WHITE

This wire should be connected to the parking light wire in the vehicle. See Set-

ting the light flash polarity section of this guide for polarity settings.

Note: For parking light circuits that draw 10-amps or more, the internal jumper

must be switched to a (-) light flash output. (See Setting the light flash polarity

section of this guide.) P/N 8617 or a standard automotive SPDT relay must be

used on the H1/11 light flash output harness wire.

H1/12

ORANGE

This wire supplies a (-)500 mA ground as long as the system is locked and when

the remote start is activated. (This feature can be turned off by programming the

anti-grind option Off). This output ceases as soon as the system is unlocked. The

GWA can be hooked up to an optional starter kill/anti-grind relay control mod-

ule, a voice module or any accessory that requires a ground when armed.

Note: The one time bypass feature does not disable function.

PARKING LIGHT OUTPUT

(+) Positive Light Flash Output

WHITE H1/11

(+) LIGHT FLASH OUTPUT

(-) Negative Light Flash Output

WHITE H1/11

(-) LIGHT FLASH OUTPUT

(-) 500mA GROUND WHEN ARMED OUTPUT

Table of Contents

Show Quick Links

Table of Contents