Contents Government regulations ...5 Warning! Safety first ...7 What’s included ...9 Important information ...9 Your warranty...9 Replacement remote controls ...9 System maintenance ...10 Low battery indicator ...10 Battery replacement ...10 Two car operation ...11 1-way remote ...12 Transmitter configuration ...13 Feature list ...14 Using the system ...17 Locking the vehicle ...17...
Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
Page 6
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to services authorized by IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device.
Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter.
Page 8
Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition.
What’s included • Two five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control center with integrated status LED and Valet override switch • A remote start defeat toggle switch • Window decals • Your warranty registration Important information Congratulations on the purchase of your state-of-the-art remote start and keyless entry system.
➤ System maintenance The system requires no specific maintenance. Your remotes are powered by small coin cell lightweight 3-volt lithium batteries that last approximately one year under normal use. The remote uses one CR2032 cell battery. When the battery begins to weaken, the operating range is reduced. ➤...
Reposition all parts and snap together. ➤ Two car operation You can use the remote control system for two cars, with full command capabil- ity for both vehicles. To change the car selection: • Press and hold the once or twice indicating the current vehicle: One blink: Car 1 Two blinks: Car 2 •...
1-way remote Description Feature Transmit indicator Lock button Unlock button Remote start button Auxiliary button Function button Note: If Keypad Lock is On, press Press for one second to lock. Press for one second to unlock. Press for one second to activate remote start.
➤ Feature list Unlock Command Press one time to Lock Notes Press/hold for 1.5 seconds to lock the system and then activate the Panic output* Unlock Command Press one time to Unlock A U X Remote Start A U X Command Press one time to activate Remote Start Aux (trunk)
Page 15
Runtime reset Command : Press Notes Re-starts the remote start runtime counter if remote start is active. Aux 1 Command : Press Notes This is an optional feature. See your sales rep/installer for details. Valet mode Command : Press Notes: Prevents the system from automatically activating the Failsafe Starter Kill and locking the door passively.
Page 16
Smart start Command : Press Notes Enables or disables the Smart Start feature. The parking lights flash fast 5 times when turning the feature on, and flash slowly 5 times when turning the feature off. Aux 3 Command : Press Notes This is an optional feature.
Using the system ➤ Locking the vehicle To lock the vehicle, press the The horn in the vehicle “honks” one-time, and the parking lights flash one-time. If the power door locks have been connected, the doors lock. The system automatically checks for errors when it locks. If errors are found when locking: If the door is open when you lock the vehicle, the horn honks once and the parking lights flash.
➤ Valet mode You can prevent your system from automatically activating the Failsafe® Starter Kill. When the system is in Valet mode, the feature is disabled. The doors do not automatically lock. This is useful when washing or having the vehicle serviced.
➤ Remote feature programming The remote control has a menu for programming user features. Before you start make sure the keypad is unlocked. (See page 12) To program the remote user features: Press and hold the car indicator at 3 seconds). The remote transmit LED turns on solid to indicate the Main Menu.
➤ Overriding the optional starter kill To bypass the optional starter kill without a remote control: Use your override switch located on the control center (see diagram below) to bypass the system. This switch bypasses the system only if you have the vehicle key.
Using the remote start Read this user guide, including the Warnings section at the beginning of this guide before using the remote start. Ensure that the vehicle is parked in an open area, not in a garage. To use your remote start to pre-warm or pre-cool your vehicle, remember to set the climate controls to the desired settings before shutting Off the engine.
➤ Manual transmission vehicles If the vehicle has manual transmission the proper steps must be followed before leaving the parked vehicle, or the remote start feature is disabled. This process is called MTS, manual transmission start. While the vehicle is running, put the transmission in neutral. Press the vehicle’s foot brake.
➤ Timer mode This unit can be programmed to start and run the engine every three hours, for a maximum of six cycles. The engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine. Note: This feature works only when the system has been locked with the remote.
To exit timer mode without the transmitter: Make sure the remote start system is not operating the engine. Turn the ignition on. Timer Mode is exited and the parking lights flash slowly four times. Note: The Bitwriter can change the amount of times the remote start activates and, it can change the intervals between activations in timer mode.
To enter turbo timer mode with a manual transmission: Perform the manual transmission procedure (See p. 22) with the door open. Transmit the timer mode feature with the remote by pressing two-times, and then press A U X After exiting the vehicle, lock the system and the vehicle remains running for the programmed runtime.
Page 26
To activate Smart Start mode: • Press the button on the remote 3 times and then press the The parking lights flash 5 times fast to confirm the remote is in Smart Start mode. To activate Smart Start mode with a manual transmission: Enter the MTS procedure.
➤ Turning on the rear defogger The rear defogger (if connected) is programmed to automatically activate when remote start is turned on. If the interior cabin temperature is above 55˚ F the defogger will not activate. To manually activate the rear defogger after remote start is on: •...
Safety features This system has several important safety features to ensure proper operation of the motor and prevent accidental damage to the engine or its components. ➤ Optional starter anti-grind circuitry Whenever the vehicle is remote started, advanced anti-grind circuitry prevents the starter from engaging, even if the key is turned to the start position.
Diagnostics The microprocessor at the heart of the system is constantly monitoring the switches that are connected to the main unit. ➤ Locking If the system is locked at the same time that the door input is active, you will hear one horn honk to indicate locking, and then a second horn honk to indicate Bypass Notification.
Owner recognition Owner recognition lets up to four users of the system have unique settings to meet their specific needs. It is almost like having four separate systems in your vehicle, one for each user. This feature is only available to authorized dealers using the Bitwriter or Bitwriter 2 program tool.
Programming options Your system has many custom programmable options. Some may require instal- lation labor. Ask your authorized dealer for details. The following is a list of the programmable options, with the factory settings in Bold. • Active locking (remote only) passive locking, the system automatically locks the doors 30-seconds after the last door is closed;...
Convenience expansions Listed below are some of the expansion options available. Please consult your dealer for a complete explanation of all the options available to you. Power Trunk Release: The accessory output of the system can operate a fac- tory power release for the vehicle’s trunk or hatch. Sometimes an optional relay is required.
Glossary of terms Control Center: The control center contains the system’s radio-frequency antenna, the valet and override switch, and the Status LED. For maximum remote-control range, the Control Center is usually located at the top of the windshield, centered near the rear-view mirror. Control Module: The “brain”...
Quick reference guide • Locking To lock press for one second. The doors lock. The LED on the control center flashes and the horn honks one time. (if connected). The parking lights flash once to confirm locking. • Unlocking To unlock press two times.
Page 36
• Remote Start Press . The parking lights turns on (if connected). The vehicle starts and runs for the programmed duration. • Rear Defogger Press four-times, and then press The parking lights flash 4 times confirming activation of the defogger output.
Limited lifetime consumer warranty Directed Electronics. (“Directed”) promises to the original purchaser to repair or replace (at Directed’s election) with a comparable reconditioned model any Directed unit (hereafter the “unit”), excluding without limitation the siren, the remote transmitters, the associated sensors and accessories, which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided the following conditions are met: the unit was purchased from an authorized Directed dealer, the unit was professionally...
Page 38
WITHOUT LIMITATION, LIABILITY FOR THEFT, DAMAGE AND/OR VANDALISM. THIS WARRANTY DOES NOT COVER LABOR COSTS FOR MAINTENANCE, REMOVAL OR REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA.