P-In-P
Picture-In-Picture (P-In-P) places an image on the PGM or PVW screens.
Start
P-in-P Src
Keyer
Position
P-In-P
Border
DSK
Border
Still
Crop
User
Crop
Inputs
Setup
P-In-P Source
This sub-option allows the user to assign the P-In-P source; various options are listed below:
Black
Input1
Position
The user is allowed to adjust the position of the PIP screen by adjusting values of X, Y and SIZE, where X is the
horizontal position, Y is the vertical position and Size is the PIP screen size.
X
Positive value: position the PIP
image to the right
Negative value: position the
PIP image to the left
Zero value: Position the PIP
image at the center
Border
PIP border color can be adjusted by adjusting the Luma, Saturation and Hue values. Width of the border can also
be adjusted.
Crop
The PIP image crop can be adjusted by modifying the following parameters:
•
Left – Adjusts the position of the left edge of the PIP image
•
Right – Adjusts the position of the right edgeof the PIP image
Size – Adjusts the PIP image crop size
•
Top – Adjusts the position of the top edge of the PIP image
•
•
Bot – Adjusts the position of the bottom edge of the PIP image
X
Luma
Width
Left
Top
Input2
Input3
Y
Positive value: move the PIP
image up
Negative value: move the PIP
image down
Zero value: Position the PIP
image at the center
Black
20% Y
0 Sat
0
0 Right
0 Bot
Input 4
Still
Size
Ranges from 0 to 100 with 0 being the
smallest and 100 being the largest
20
10% Size
50%
0 Hue
0.0
0 Size
0
Freeze
Matte
0
Bars