Troubleshooting - Magnavox mrd120 User Manual

Troubleshooting

WARNING
Under no circumstances should you try to repair the system yourself, as this will
invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for
repair. If you are unable to remedy a problem by following these hints, please
call 1-800-705-2000 for help.
Problem
No power.
No picture.
Completely distorted picture or
black/white picture.
The aspect ratio of the screen cannot be
changed even though you have set the
TV display.
No sound or distorted sound.
The DVD system does not work.
The disc tray cannot open and "TRAY
LOCKED" is displayed.
34
001-037-MRD120-37-Eng
– Check if the AC power cord is properly
connected.
– Press the STANDBY ON on the front of the
DVD system to turn on the power.
– Refer to your TV's manual for correct Video In
channel selection. Change the TV channel until
you see the DVD screen. (see page 16)
– Press DISC on the remote.
– Switch the P-SCAN at the back panel to
"OFF" position if you are not using a
Progressive Scan TV.
– If this happens when you changing the setting
of the 'TV SYSTEM', wait for 15 seconds for
auto recovery. (see page 17)
– Check the video connection. (see pages 10-11)
– Sometimes a small amount of picture
distortion may appear. This is not a
malfunction.
– Clean the disc. (see page 7)
– The aspect ratio is fixed on the DVD disc.
– Depending on the TV, it may not be possible to
change the aspect ratio.
– Adjust the volume.
– Check the speaker connections and settings.
(see pages 9, 18)
– Disconnect the headphones.
– Press the correct source button on the remote
(TV/AV or AUX, for example) to choose the
equipment that you want to hear through the
DVD system. (see pages 10, 11, 13)
– Disconnect the power cord from the power
outlet for a few minutes. Reconnect the
power cord and try to operate again as usual.
– Press and hold SOURCE button on the front
panel for more than two seconds, then press
PLAY button.
34
Solution
8239 300 30533
18/03/2004, 02:20 PM