Interlogix TruVisioin 12 Series Installation Manual page 27

6. Route the cables through the side hole of the dome by
removing the cover.
7. Connect the video output connector to the monitor.
Connect the power connector to the power supply.
8. View the camera image using the monitor. Adjust the
pan, tilt and azimuth angle. Loosen and adjust the zoom
and focus lever to obtain the appropriate angle of view
and optimum focus.
2) Zoom and focus adjustment.
Loosen the zoom lever and move the lever between
T(Tele) and W(Wide) to obtain the appropriate angle
of view.
3) Tighten the zoom lever.
Loosen the focus lever and move the lever between
F(Far) and N(Near) to obtain the optimum focus.
Tighten the focus lever.
Installation Guide 23