TRENDnet TV-IP430PI User Manual page 8

TRENDnet User's Guide
6. Select the DHCP option to assign IP address dynamically, or select Fixed IP to
assign the camera an IP address, then click Next.
7. If you select Fixed IP, enter the IP address, subnet mask, default gateway, and
DNS server address. Please make sure the IP address you are setting on the
camera is in the same network of the computer that you are using. Click Next.
© Copyright 2015 TRENDnet. All Rights Reserved.
8. Enter a new password. The default password is admin. You are required to
change the password from the default setting to prevent unauthorized access.
Enter the default password: admin and enter the new passwords for a brand
new installation*. The password must be between 8 and 16 characters.
(Alphanumeric: a-z, A-Z, 0-9, !, @, #, $).
*This camera installation wizard is also good for finding the camera if it was setup with
DHCP. The IP address may change dynamically with the DHCP setting. If you want to
access your camera again and you don't know the IP address, you can run this camera
installation wizard again. If you have already setup the password and want to keep the
password unchanged, un-check the Change Password box and click next to get the link
to access your camera.)
** Please save the password for future references. This device does not have a
hardware reset function for temper proof purpose.
TV-IP430PI
6