Green Routing Settings; Map Settings - Clarion NX501E Owner's Manual & Installation Manual

Route Planning Method types:
Button
Gives a quick route if you can travel at or near the speed limit on all roads. Usually the best
selection for fast and normal cars.
Gives a short route to minimise the distance to travel. It can be practical for slow vehicles.
Searching for a short route regardless of the speed, this route type is rarely practical for
normal vehicles.
Gives a quick but fuel efficient route based on the fuel consumption data given in Green
Routing settings (page 47). Travel cost and CO
They cannot take elevations, curves and traffic conditions into account.
Results in a route with fewer turns and no difficult manoeuvres. With this option, you can
make Clarion Mobile Map to take, for example, the motorway instead of a series of smaller
roads or streets.

4.3.5 Green routing settings

These settings determine how Green routes will be calculated. They are also used to display the cost and CO
emission
Button
Enter the average consumption of your vehicle when used in built-up areas. If necessary, tap
Enter the average consumption of your vehicle when used on highways. If necessary, tap
Select the engine and fuel type of your vehicle. This helps in estimating the CO
Enter the average fuel price for travel cost calculation. If necessary, tap
select
If the selected routing method is not Green, you can have your route compared to the best
green alternative on the screen when confirming the route. If this alternative is much better
than the selected method, you can quickly switch to Green mode.

4.3.6 Map settings

You can fine-tune the appearance of the Map screen. Adjust the map view to your needs, choose suitable colour
themes from the list for both daytime and night use, change the red arrow to a 3D car model, show or hide 3D
buildings, turn track logging on or off, and manage you Place visibility sets (which Places to show on the map).
The map is always shown on the screen so that you can see the effect when you change a setting.
Button
Switch the map view between a 3D perspective view and a 2D top-down view.
Adjust the basic zoom and tilt levels to your needs. Three levels are available.
Switch between daytime and night colour modes or let the software switch between the two
modes automatically a few minutes before sunrise and a few minutes after sunset.
Select the colour scheme used in daytime mode.
Downloaded from Caradio-Manual.com Manuals
Description
of
Description
and select
and select
to change the currency.
Description
emission calculations are estimations only.
2
to change the measurement unit.
to change the measurement unit.
2
routes.
emission.
2
and
NX501E/NZ501E 47