Customise Quick Menu; Traffic Settings; Route Settings - Clarion NX501E Owner's Manual & Installation Manual

Button
The application can warn you when you approach road safety cameras like speed cameras
or dangerous areas like school zones or railroad crossings. Tap this button and set the
different alert types individually. The following alert types are available: Audio warning:
beeps or the name of the alert type can be played while you are approaching the camera,
or extra alert sounds if you exceed the speed limit while approaching one of these cameras.
Visual warning: the type of the alert point, its distance and the related speed limit appear
on the Map screen while you are approaching one of these cameras. The distance from the
camera is also displayed. For some of the alert points, the enforced or expected speed limit
is available. For these points, the audio alert can be different if you are below or above the
given speed limit. Only when speeding: The audio alert is only played when you exceed the
given speed limit. When approaching: The audio alert is always played. In order to draw your
attention, the alert can be different if you exceed the speed limit. Road safety cameras are
not displayed in the list when GPS position is not available or if you are in certain countries
where road safety camera warning is prohibited.
Maps may contain driver alert information. Tap this button to turn on or off these warnings and
to set the distance from the hazard to receive the warning at. These can be set individually for
the different warning types.

4.3.2 Customise Quick menu

The content of the Quick menu (page 14) is fully customisable. Tap the button you want to change, and select its
new function from the list.
The list of available functions and their descriptions are on page 14.

4.3.3 Traffic settings

The recommended route is not always the same between two points. Whenever suitable data exists, traffic
information can be taken into account in the route calculation
Button
Use this switch to enable or disable the TMC receiver that can receive real-time traffic
information. The rest of the buttons below are all related to the TMC function and are available
only if the receiver is enabled.
This setting determines how Clarion Mobile Map uses the received real-time traffic information
in route calculation. When calculating a new route, or when recalculation becomes necessary
based on the received Traffic events, Clarion Mobile Map avoids traffic events if it makes
sense.
You can also set the minimum delay that triggers route recalculation, and you can instruct the
application if you want to confirm every recalculation.
Tap this button to open the list of traffic event types, and select which events to take into
account in route calculation.
Tap this button for the list of available TMC service providers.

4.3.4 Route settings

These settings determine how routes will be calculated.
Button
You can set the type of vehicle you will use to navigate the route. Based upon this setting, some
of the road types can be excluded from the route, or some of the restrictions may not be taken
into account in route calculation.
The route calculation can be optimised for different situations and vehicle types by changing
the planning method. See below for details.
To let the route fit your needs, you can also set which road types are to be considered for or to be excluded from
the route if possible.
Downloaded from Caradio-Manual.com Manuals
Description
Description
Description
NX501E/NZ501E 45