Table of Contents
Advertisement
Temporary Override Menu
The Temporary Override Menu is used to change tempera-
ture set points, Mode of Operation, and the Zone status
(OCCUPIED or UNOCCUPIED) for a designated length of
time without having to change what typically would be the
Normal Program. If Option 10 is set to 1, then the Fan
Mode
will be displayed and programmable. Refer to the Tempo-
rary Override Menu screen illustration.
Note: Changing option 9 or 10 will erase the current
program setting.
To enter the Temporary Override Menu;
If option 14 in the Options Menu (Keypad Lockout) is en-
abled and the Lock icon is visible, press and hold the Posi-
tive ("+") and Negative ("-") side of the TIME KEY simulta-
neously to unlock the keypad.
1. From the Normal Run State, press the HOLD TEMP
KEY or either the UP or DOWN KEY.
2. The HOURS icon located under the right two digits of
the clock will be blinking. Press the Positive ("+") side
of the TIME KEY to increase the number of hours the
override program will last. Press the Negative ("-") side
of the TIME KEY to decrease the number of hours.
3.
Press the DAY KEY to toggle from the Hours icon to
the Days icon. Press the Positive ("+") side of the TIME
KEY to increase the number of days the override pro-
gram will last. Press the Negative ("-") side of the TIME
KEY to decrease the number of days.
4.
Press the UP or DOWN arrows to program the tem-
perature set points (HEAT and/or COOL). Use the
MODE KEY to toggle between the Modes if applicable.
Programming And Operation
5.
Press the FAN KEY to program the fan for ON or AUTO
operation during the override period.
6.
Press and hold the UP and DOWN arrows simulta-
neously for 2 seconds to toggle the zone status be-
tween OCCUPIED and UNOCCUPIED.
7.
Pressing the ERASE KEY will cancel any override pro-
gramming and return the sensor to the Normal Run
State.
8.
Press the HOLD TEMP KEY to confirm the program
and to start Temporary Override. If no keys are
pressed, the sensor will return to the Normal Run State
and ignore the override program.
Entering the Temporary Override Screen
Once the override program has begun and the Keypad
Lockout is disabled, the MODE KEY will allow the operator
to change the System Mode. The ERASE KEY can only be
used to cancel the CHECK FILTER signal if displayed. The
FAN KEY will exit the Temporary Override Program and en-
ter the Temporary Override Menu screen. All other keys are
disabled. Refer to the Temporary Override screen illustra-
tion.
To Exit the Temporary Override program;
1. Press either of the UP or DOWN arrows, the HOLD
TEMP KEY, or the FAN KEY. (Returns sensor to the
Temporary Override Menu)
2. To change the program parameters, refer to the previous
programming steps 2 through 8.
3.
To return to the Normal Run State from the Temporary
Override Menu, press the ERASE KEY.
14
Hide quick links:
Advertisement
Table of Contents
