Chapter 6 Configuring Your Device; Home Page (Dashboard) - Multitech MultiConnect rCell 100 User Manual

CHAPTER 6 CONFIGURING YOUR DEVICE

Chapter 6 Configuring Your Device

Home Page (Dashboard)

This page provides a high-level view of the MultiConnect rCell device.
Click Home to display the following information:
■
Router:
■ Model Number: The MultiConnect rCell model ID.
■ Serial Number: The MultiTech device ID.
■ IMEI: International Mobile Station Equipment Identity.
Note: Not applicable for the MTR-C2 or MTR-EV3 models.
■
MEID: Mobile Equipment Identifier.
Note: Only for the MTR-C2 or MTR-EV3 models.
■
Firmware: MultiConnect rCell MTR firmware version.
■
Current Time: Current date and time of the router. For information on setting the date and time go to
Setup > Time Configuration.
■ Up Time: Amount of time the device has been continously operating.
■ WAN Transport: Current transport for IP traffic leaving the LAN. If two WAN interfaces are configured for
use (Wi-Fi and cellular), the current WAN will be set based on the WAN configurations at Setup > WAN
Configuration.
■ LAN:
■
MAC Address: Media Access Control Address used to uniquely identify the devices LAN Ethernet
interface.
■ IP Address: LAN IP address of this device. To configure the IP address go to Setup > IP Configuration.
■ Netmask: Network mask of the LAN. To configure the network mask go to Setup > IP Configuration.
■ Gateway: Default gateway IP address of the LAN. To configure the default gateway go to Setup > IP
Configuration.
■
DNS: Current Domain Name System IP addresses known by this device. To configure the DNS go to Setup
> IP Configuration.
■
DHCP State: Current state of this device's DHCP server. To configure go to Setup > DHCP Configuration.
■
Lease Range: Current DHCP lease range of this device's DHCP server. To configure go to Setup > DHCP
Configuration.
■ Cellular:
■ State: Current state of the cellular PPP link. For more information go to Cellular > Cellular Configuration.
■
Signal: Current signal strength of the cellular link. Mouse hover provides dBm value.
■
Connected: Total time connected for the current PPP session.
■
IP Address: Current cellular WAN IP address issued to this device by the cellular carrier.
■
Roaming: Indicates whether or not this device's cellular like is currently connected to its home network.
■ Phone number: Device's cellular phone number also known as Mobile Directory Number (MDN).
■ Tower: Tower ID of the cellular tower currently providing cellular service to this device.
28
®
MultiConnect rCell 100 MTR-H5 User Guide