Table of Contents
Advertisement
Auto Cutting
Feed Rate by spring holding
Turn toggle switch to down location. Select
spring as outer location. Press green button
down to start auto cutting.
Cutting mode switch
Manual Cutting
Feed Rate by Handle with Trigger
Switch
Turn toggle switch to upper location.
Select spring as inner location.
Push down the trigger switch for cutting material
by handle.
For auto cutting
For manual cutting
Trigger switch
Angle Cutting
The machine uses a swivel miter base for angle
cutting from 0 ~ 60 degree. On the sawing arm,
there is an attached scale (Q) in Fig.7. This
machine is preset zero degree before leaving
the factory. Angle cutting is adjusted as follows.
1.
Loosen handle (R) Fig.7 to release the arm.
2.
Move this swivel arm forward along the
scale to search a right index for the work to
be cut.
3.
If the pointer matches the right index on the
scale. Tighten the handle, and a perfect
angle cut will be given.
Disconnect machine from the power source!
No matter when, where, or how. Pay extra
attention to the saw during it in transportation,
operation, and maintenance. Or adjustment.
Failure to comply may cause serious injury!
Changing Blade
1.
Raise this saw head up-to proper position
by lifting up the arm Fig. 8.
- 8 -
R
Q
Fig. 7
WARNING
Fig. 8
Advertisement
Table of Contents
