Resetting Service Functions To Factory; Settings; Select Max. Or Min. Heat Output; Reset The Appliance - Worcester CDi Combi N.G Service Booklet

4.5.3 Exit service function/service level without
storing
B Press the button to exit the service function
without storing. After releasing the button goes out.
First service level is active.
B Press eco button and
3 seconds (the display shows
the first service level. Afterwards the display shows
the last selected service function.
-or-
B Press the button to exit all service levels. After
releasing the button goes out.
4.6

Resetting service functions to factory

settings

To reset all settings on Service levels 1 and 2 to the
factory settings:
B Display the value of the service function 8.E (second
service level, value = 0) and store it. The appliance re-
starts with factory settings (see also section 3.1).
4.7

SELECT MAX. OR MIN. HEAT OUTPUT

B Press the button for approximately 10 seconds (the
display shows ). When the button will light up
orange, release it.
B Turn the CH control knob on the right and adjust
maximum heat output (the display shows alternatively
the CH flow temperature and
-or-
B Turn the CH control knob on the left and adjust
minimum heat output (the display shows alternatively
the CH flow temperature and
B Press the button to exit the function. After
releasing the button goes out.
Maximum or minimum heat output is only
active for 15 minutes. After this time the
appliance changes to normal mode.
4.8

RESET THE APPLIANCE

B Press the reset button for 3 seconds and release.
After releasing button the appliance
re-starts without parameter reset.
(For a parameter reset see section 3.6).
8 716 115 748 (2009/09)
Supplied By www.heating spares.co Tel. 0161 620 6677
simultaneously for
) in order to go to
).
).
OPERATION - HIGHFLOW CDI AND FS CDI REGULAR
17